Case Studies
13T EXCAVATOR BUCKETS
Here we have two bucket attachments that came to the workshop for wear upgrades. As seen in the photos the client opted to have these welded ensuring they have a longer lifespan.
New teeth and cutting edge have been installed as well as any welding repairs needed to bring the attachments back into service.
BOILER HOUSE WALKWAY
A much needed walkway upgrade/replacement carried out. After a partial collapse of the existing walkway, SRL were bought in for the urgent strip down and re-build of the suspended walkway which includes new supporting frames and durbar floor plates. All works had to be carried out on site due to the severity of the collapse as this is a main passageway and fire route for the building.
18T GRAB BUCKET REPAIR
An emergency call had been made by our client on a Friday afternoon as their 18T grab had smashed apart during routine works in our clients waste yard. We collected and bought it back to the workshop to investigate the damages. After re-constructing the body and adding additional strengthening plate and welds we were able to deliver the attachment back the following Monday morning
LOADER BUCKET MODIFICATIONS
We were called to site to install webbing plates on the side of this loader bucket to allow the clients use of the machinery to be more broadly efficient when loading the lorries with fine material.
FISHING BOAT RUDDER RE-MANUFACTURE
Here is an example of what we can achieve over one weekend when responding to an emergency call-out. We were called out to a Marina in Hampshire after a fishing boat had lost its rudder at sea making it impossible to steer the boat. We got straight onto site to measure and design a replacement. All in, this project was completed within three days ensuring the boats downtime was kept to a minimum.
LOADER ATTACHMENT HOOKS
Our client got in contact with us to take a look at an issue they had regarding using existing loader attachments on new pieces of equipment that they had purchased. We were able to identify the issues to come up with a solution to enable them to use the attachments on every piece of machinery by fabricating a new set of hooks and modifying the existing attachments.
STEAM PIPE RE-MANUFACTURE
We were called out to this project to address a problem the client had after installing a new steam washing system, as you can see by the photographs the existing pipework didn't line up with the new inlet. We were able to take out that section, re-design, fabricate and install a new pipe to suit.